POS overlay Box Setting for netZeye v6.0
Notice:) Please make
sure Capture Card software is version 6.0 or later.
 
POSoverlay box is
compatible with PC base cash register. Printer need to be TEXT output
format. no graphic.
Also, current posoverlay is compatible with Serial Printer. Some of the
LPT printer also supported but no guarantees
1. Please make sure your printer model and connection type.
For example, please make sure your printer is Serial Printer or LPT printer?
Who makes? General or EPSON printer?
2. Please
make sure your cable connect correctly. If you are using 25pin
cable to connect, make sure it is Serial printer or LPT printer.
sometime, they are
all looking sames. If you are using Serial,
please make sure you connect to Serial RS-232 connect port on the box.
Do not use Parallel port to connect Serial printer. It doesn't work that
way.
3. Please
make sure your printer communication speed and signal. Baud rate speed,
parity and others.
| 1 |
Go
Setup button
and click POS Application Setting |
 |
| 2 |
Create a New POS station map with camera connection |
 |
| 3 |
Setup as seen. |
 |
| 4 |
Finish Setting |
 |
| 5 |
Go to computer device manager, we need to config your com port to
correct baud rate. |
 |
| 6 |
select COM port and change properties |
 |
| 7 |
change as seen.
Make sure your flow control to Xon / Xoff |
 |
| |
|
|
| |
Start to Record at netZeye system.
And, Print couple receives from your POS station.
You should see your screen will show the receive text message. |
| 8 |
Go ViewLog button.
and click System Log
Change to POS1
Double click the Text Line.
for example, Line 5280 |
 |
| 9 |
You should see this.
click Play will play the Video and receive message together. |
 |
| |
|
|
| |
Serial
Connect Picture Example |
|
| |
Usually, printer
cable is 9pin for serial.
but if you have
25pin or other types. Please make sure you convert it into 9pin
and connect to here.
You need to
purchase converter from 25pin to 9pin and 9pin to 25pin two adaptor.
Test connect
without the pos overlay box, to see the printing is work or not
first.
POS->25pin->9pin-->9pin->25pin->printer
If print
works, then we can proceed to connect posoverlay box.
|
|
| |
Setting for
Serial cable is same as on the top (1~9).
The only different
are
a. make sure your posoverlay box dip switch is
correct.
and b. make sure your printer speed is correct
set in the setup. (as picture 3) |
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
|
