DDNS
The Dynamic DNS is an application that allows users to register domain
names that always point to their Multicam systems. This application
is only necessary when your Multicam system is using a dynamic IP address.
If so, the DDNS will update Multicam system’s IP address to DNS
Server in every 10 minutes. Therefore, even if your Multicam system’s
IP address changes, you can still locate it by using the registered
domain name.
Dynamic DNS
supports Windows XP, Windows 2000, and Windows Server 2003 only, but
not supports Windows 95/98 or ME.
Dynamic DNS
uses ports 80 and 81 to upload IP address over the Internet. If your
Multicam system is connected behind a router or firewall, make sure
port 80 and 81 are open. Dynamic DNS will only upload global IP addresses.
If your Multicam system is using virtual IP, NAT port mapping should
be done first.
| 1 |
Locate
DDNS Setup program from Setup CD
Open DDNS Folder. |
 |
| 2 |
Run Setup Program |
 |
| 3 |
Go Next |
 |
| 4 |
Go
Next |
 |
| 5 |
Go
Next, And Finish Setup |
 |
| |
Run DDNS software |
|
| 6 |
Minimize Your
Multicam software. |
 |
| 7 |
Double Click Program to Start |
|
| 8 |
Click Register |
 |
| 9 |
If you cannot
see this page, close it and reopen it again. Sometime it cause by
service busy.
Register
your DDNS website name
For
example,
If you choose "netZeye" as your username, your DDNS website
name will be:
http://netZeye.dipmap.com
|
 |
| 10 |
After you
get Send,
You should get confirm information
Click [x] to
close this information page. |
 |
| 11 |
Now, you are
back to this screen.
Please enter
username & password that you just created.
Click Save. |
 |
| 12 |
After
You click Save,
You should see
Update successful
messege.
If you still see Failure messege, possible situation:
1. Server busy. Maybe it take more time to update, try again later.
2 . Is your
Multicam software minimize? If not, please make sure Multicam software
is ON.
3 . Is your Port 80,81 allow to transfer signal? |
 |
| 13 |
Please click [ _ ] Minimize
Remember:
Do not chose close the program.
If you close it, then your webname cannot update automatically. |
  |
| 14 |
Open Internet Explorer
type:
http://netzeye.dipmap.com
If you use different port number than 80, please type
http://netzeye.dipmap.com:2550 |
 |
| |
|
|
| |
|
|
|
